Holden Colorado Owner Manual (Australia-Localizing-Australia-12333014) -
2019 - crc draft - 3/1/18
Instruments and Controls 77
A Driver Information Centre (DIC)
tyre pressure message may also
display. See Tyre Messages 0 85.
Stop as soon as possible and inflate
the tyres to the pressure value
shown on the Tyre and Loading
Information label. See Tyre
Pressure 0 249.
When the Light Flashes First and
Then Is On Steady
If the light flashes for about a minute
and then stays on, there may be a
problem with the TPMS. If the
problem is not corrected, the light
will come on at every ignition cycle.
See Tyre Pressure Monitor
Operation 0 252.
Engine Oil Pressure Light
.
The
: warning light
illuminates for a short time when
the ignition is turned on to show
that the light is working.
If the light illuminates while driving:
.
The oil pressure is
dangerously low.
Stop the vehicle as soon as
possible and check the engine
oil level.
.
See Engine Oil 0 230.
.
Do not drive the vehicle with the
light illuminated. Contact a
Holden Dealer.
Caution
Engine damage may result if you
keep driving. Do not run the
engine. If the oil level is normal,
have the system checked by the
nearest Holden Dealer.
Low Fuel Warning Light
The . warning light illuminates for
a short time when the ignition is
turned on to show the light is
working.
.
The light illuminates when the
fuel tank is approaching empty.
Add fuel as soon as possible.
.
If the fuel tank is run to empty,
the fuel system must be bled.
See Diesel Fuel System
Bleeding 0 237.
See Fuel 0 216 and Fuel System
Messages 0 83.
Immobiliser Light
.
The
A warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
If the light remains on, contact a
Holden Dealer.
.
See Immobiliser 0 26.
High-Beam On Light
The 3 indicator light illuminates
when headlamp high beam is on.
See Headlamp High/Low-Beam
Changer 0 90.
To Next Page
Loading...
