158 Driving and operating
Object detection
systems
Park Assist (PA)
The PA system is able to detect and
indicate obstacles at the rear of the
vehicle when reversing.
The system consists of four sensors
on the rear bumper.
Warning
The driver is always responsible
for taking care and attention while
manoeuvring the vehicle. The
PA is only an aid and is neither
intended to, nor able to take over
any responsibility.
The park sensors may not be
able to detect all objects under
every condition e.g. objects too
close to the vehicle, objects
above or below the sensors,
or objects with a surface that
absorbs ultrasonic waves.
Additionally, some ambient
conditions like ultrasonic
waves or heavy rain can cause
disruptive reections from an
object’s surface. Such objects
may not be detected.
Always manoeuvre the vehicle
slowly to allow yourself sufcient
time to react. The warning tones
may not sound if the vehicle’s
speed is above 10 km/h.
Activation
The system is activated
automatically when:
• The ignition is turned on.
• Reverse gear is selected.
Alarm tones
• Alarm tones sound when an
object is detected.
• The interval between the alarm
tones becomes shorter as the
vehicle gets closer to an object.
• When the distance is less than
40 cm, the alarm tones sound
continuously.
• If the vehicle stops, the
alarm tones will stop after
approximately 3 seconds.
To Next Page
Loading...
