Vehicle care 201
6. Place the switch on the
compressor to O.
7. Screw the compressor air hose
to the connection on the sealant
bottle.
8. Connect the compressor plug
to the accessory socket (power
outlet).
9. Start the engine and let it idle
to ensure the battery does not
run down.
Note
If running the engine ensure
neutral or P is selected.
Warning
Do not run the engine in
an enclosed area or with
passengers in the vehicle.
Fuel 0 164
10. Place the compressor near
the tyre so the sealant bottle is
upright.
11. Unscrew the valve cap from the
defective tyre.
12. Screw the ller hose to the
tyre valve.
13. Press the switch on the
compressor to I.
The tyre lls with sealant.
The compressor pressure gauge
briey indicates up to 6 bar while
the sealant bottle is emptying
(approx. 30 seconds).
The pressure starts to drop.
Once the sealant is pumped into
the tyre, the tyre is inated.
The prescribed tyre pressure
(approximately 2.4 bar) should
be obtained within 10 minutes.
To Next Page
Loading...
