EasyManua.ls Logo

HOLDEN MY19 TJ Trax - Central Locking System; Memorised Settings

HOLDEN MY19 TJ Trax
234 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
22 Keys, doors and windows
Fault
If the central locking cannot be
operated or the engine cannot be
started, the cause may be one of the
following:
Fault in electronic key.
Electronic key out of reception
range.
Battery voltage too low.
Overload of the central locking
system by operating at frequent
intervals, the power supply is
interrupted for a short time.
Interference from higher-power
radio waves from other sources.
To rectify the cause of the fault,
change the position of the electronic
key.
Central locking system 0
22
To start the vehicle with a low
transmitter battery.
Starting the engine 0
142
Memorised settings
Whenever the key is removed from
the ignition switch, or for vehicles
with electronic key system, after the
Engine Start/Stop button is pressed
off, the following settings may be
automatically memorised by the key:
• lighting
infotainment system
central locking system
comfort settings
This can be set for each key used.
Central locking system
Doors may be locked and unlocked
by pushing buttons on:
The driver’s or front passenger’s
door.
The key from inside or outside
the vehicle.
Note
The driver’s door must be closed for
the driver’s door to lock.
Vehicle personalisation 0
83
Central locking button
Drivers door

Table of Contents

Related product manuals