Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
122
phone service carriers may not
allow a merged call to become
unmerged.
Ending a Call
.
Press
i on the steering wheel
controls.
.
Touch End on the infotainment
display to end all existing calls,
or touch End next to a call to
end only that call.
Some phone service carriers may
not allow a merged call to become
unmerged.
Dual Tone Multi-Frequency
(DTMF) Tones
The in-vehicle Bluetooth system can
send numbers during a call. This is
used when calling a menu-driven
phone system.
1. Touch the Phone screen
button.
2. While in the Call View, touch
l to raise the Interaction
Selector.
3. Select Keypad and enter the
number.
Voice Mail
The default voice mail number is the
phone number of the currently
connected phone. The voice mail
number can be changed in
Bluetooth settings.
To dial a voice mail number:
1. Touch the Phone screen
button.
2. Select Voice Mail.
3. Select Call.
4. Enter the DTMF tones using
the keypad if needed.
Text Messaging
If equipped, the infotainment system
may allow text messages to be
received and replied to. Received
messages can also be read aloud.
Before using the text messaging
feature, check to see if the phone is
compatible.
See your dealer for details.
Text Menu
Inbox : Touch to display incoming
messages. To view a message,
press on the name of the sender.
Press
> to listen to the text
message. Press BACK on the
faceplate or press the Back screen
button to go back to the
previous menu.
Settings : See “Text Settings” later
in this section.
Reply : Touch to reply using a
predefined text message. See “Text
Settings.”
Call : Touch to place a call to the
sender of the text message.
Note
.
There may be previous
configuration required in your
mobile to have this function
working properly.
.
Due to the variety of devices and
their firmware versions, your
device may respond differently
when performing this function.
Infotainment System - MyLink with Built-in Navigation
To Next Page
Loading...
