Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
190 Driving and Operating
Operation
ABS operation is noticeable by
pulsing of the brake pedal and the
noise of the regulation process.
The initial self-check may also be
audible.
Keep the brake pedal fully pressed
throughout the braking process,
without pumping it. Pumping the
brake pedal can reduce brake
efficiency.
If the vehicle is travelling above
50 km/h and ABS braking occurs,
the centrally mounted rear high-level
brake lamp will flash.
{
Warning
When the ignition is turned on,
the
! warning light briefly
illuminates. The self-check of the
ABS may be audible.
(Continued)
Warning (Continued)
If the ! warning light (ABS off)
on the instrument panel display
does not extinguish, or illuminates
when driving, a malfunction has
occurred.
Note: The vehicle's brake system
remains operational, but without
ABS assistance. Have a Holden
Dealer check the system as soon
as possible.
See Brake and Clutch System
Warning Light 0 62.
Parking Brake
Applying the parking brake:
1. Apply the parking brake firmly
without engaging the release
button and apply as firmly as
possible when on an uphill or
downhill gradient.
Releasing the parking brake:
1. Pull the lever slightly upwards.
2. Press the release button and
lower the lever all the
way down.
To reduce the operating forces of
the parking brake, press the foot
brake at the same time.
{
Warning
Never drive the vehicle with the
parking brake applied.
See Brake and Clutch System
Warning Light 0 62.
Brake Assist
Brake Assist detects rapid brake
pedal operations due to emergency
braking situations and provides
additional braking to activate the
Antilock Brake System (ABS) if the
brake pedal is not pushed hard
enough to activate ABS normally.
Minor noise, brake pedal pulsation,
and/or pedal movement during this
time may occur. Continue to apply
the brake pedal as the driving
To Next Page
Loading...
