Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Vehicle Care 219
1. Place the support rod into the
holder.
2. Lower the bonnet to
approximately 30 cm and allow
it to drop into the catch.
3. Check that the bonnet is
engaged.
4. If it is not engaged, open the
bonnet and repeat
Steps 2 and 3.
Note
Do not push on the bonnet to close.
{
Warning
If while driving you notice that the
bonnet has not been properly
closed, pull the vehicle over to the
side of the road at the earliest
possible moment and close the
bonnet correctly.
To Next Page
Loading...
