Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Vehicle Care 233
2. From the rear side of the
bumper, rotate the bulb holder
anticlockwise to disengage.
3. Remove bulb from the holder
and replace the bulb.
4. Insert the bulb holder in bulb
housing and rotate clockwise.
Electrical System
Fuses
Fuse boxes are located:
.
In the engine compartment
.
In a storage compartment on the
driver ’s side
There is a primary fuse holder
connected to the positive
battery post.
{
Warning
Turn off the ignition (LOCK
position) and any electrical
equipment before changing
a fuse.
.
Replace blown fuses promptly.
.
A blown fuse can be recognised
by its melted wire.
.
Do not replace the fuse until the
cause of the fault has been
remedied.
.
Some functions are protected by
several fuses.
{
Warning
When replacing a fuse be sure to
use a fuse of the
specified amperage.
Never install a wire or similar as it
could damage electrical
components and cause a fire.
Any improper alterations to the
electrical system may cause a fire
hazard and engine damage. To
maintain your own safety and that
of the vehicle, have any work
involving the electrical system or
the replacement of high current
fuses or relays carried out by a
Holden Dealer.
To Next Page
Loading...
