Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
242 Vehicle Care
Caution
Tyre sealants could damage the
TPMS sensors. TPMS sensor
damage caused by using tyre
sealants is not covered by the
vehicle warranty.
The TPMS also includes a
malfunction indicator to indicate if
the system is not operating
correctly. The TPMS malfunction
indicator is combined with the low
tyre pressure light. When the
system detects a malfunction, the
light will flash for approximately
one minute and then remain
continuously illuminated. This
sequence will continue upon
subsequent vehicle start-ups as
long as the malfunction exists.
When the malfunction indicator is
illuminated, the system may not be
able to detect or signal low tyre
pressure as intended. TPMS
malfunctions may occur for a variety
of reasons, including the installation
of replacement or alternate tyres or
wheels on the vehicle that prevent
the TPMS from functioning properly.
Always check the TPMS malfunction
light after replacing one or more
tyres or wheels on your vehicle to
ensure that the replacement or
alternate tyres and wheels allow the
TPMS to continue to function
properly.
See Tyre Pressure Monitor
Operation 0 243.
Tyre Learn
The sensors are calibrated to the
tyre/wheel positions, using a TPMS
relearn tool. See your dealer for
service.
Vehicle Loading
Select SET/CLR to define one of
following options:
Light : for comfort pressure up to
3 people.
ECO : for ECO pressure up to
3 people.
Max : for full loading.
The ECO tyre pressure serves to
achieve the smallest amount of fuel
consumption possible.
Incorrect tyre pressures will impair
safety, vehicle handling, comfort and
fuel economy and will increase
tyre wear.
The tyre pressure tables show all
possible tyre combinations. See
Tyre Pressure 0 272.
If the tyre pressure is to be reduced
or increased on a vehicle with a tyre
pressure monitor system, switch off
the ignition. After adjusting the tyre
pressure, switch the ignition on and
select the desired setting as
described previously in this section.
After inflating, driving may be
required to update the tyre pressure
values in the DIC. During this time
7 may illuminate.
To Next Page
Loading...
