Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Vehicle Care 253
7. Make sure the tyre is stored
securely. Push, pull, and then
try to turn the tyre. If the tyre
moves, use the wheel wrench
to tighten the cable or chain.
Repeat this tightness check
procedure when checking the
spare tyre pressure according
to the scheduled maintenance
information or any time the
spare tyre is handled due to
service of other components.
To store the jack and tools, reverse
the steps for removing them. See
Tools 0 239.
When reinstalling the repaired
wheel:
1. Install the centre cap.
2. Place the cap on the wheel and
tap it into place until it is flush
with the wheel.
Jump Starting
Read the following warnings and
procedure in full before attempting
to jump start the vehicle.
If you are still unsure about jump
starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek the
assistance of a suitably trained
service technician.
{
Warning
Do not push start or tow start the
vehicle. Therefore, if the battery is
flat, jump start, but do not push
start the vehicle.
Batteries produce explosive
gases, contain corrosive acids
and supply levels of electrical
current high enough to cause
burns. Therefore, adhere to the
following when working near a
battery:
(Continued)
To Next Page
Loading...
