Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Seats and Restraints 37
2. Pull the shoulder belt all the
way out of the retractor to set
the lock. When the retractor
lock is set, the belt can be
tightened but not pulled out of
the retractor.
3. To tighten the belt around the
installed child seat, push down
on the child restraint, pull the
shoulder portion of the belt to
tighten the lap portion of the
belt and feed the shoulder belt
back into the retractor.
4. Try to pull the belt out of the
retractor to make sure the
retractor is locked. If the
retractor is not locked, repeat
Steps 2 to 4.
5. To remove, press the release
button on the buckle and allow
the belt to fully retract.
Selecting the Right System
Infants
Rearward facing infant capsules are
designed so that in the event of a
collision, impact forces will be
evenly spread over the baby's back,
with minimal jarring to the
vulnerable head and neck area.
Young children
Forward facing child seats are for
use when the child is able to sit and
easily hold their head upright.
Booster seats
Booster seats are for when children
outgrow a typical forward facing
child seat, but are still too small for
three point seat belts.
{
Warning
Always move the passenger’s
seat as far back as it will go
before installing a booster seat.
This locates the child as far from
the passenger’s airbag as
possible.
Remember that it is safest for
children to be seated in the rear
seats.
Older children
To Next Page
Loading...
