EasyManua.ls Logo

HOLDEN MY20 RG Colorado - Information Displays

HOLDEN MY20 RG Colorado
290 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
Instruments and Controls 65
Pre-Heat Light
The preheating system activates
only if the outside temperature
is low.
When the ignition is turned on,
K
may illuminate and will stay
illuminated until the engine is
sufficiently warmed.
See Starting the Engine 0 177.
Tire Pressure Monitoring
System Light
For vehicles with Tyre Pressure
Monitoring System (TPMS),
7
illuminates briefly when the engine
is started.
When the Light Is On Steady
If the light illuminates steady, this
indicates that one or more of the
tyres are significantly under-inflated.
A Driver Information Centre (DIC)
tyre pressure message may also
display. See Tyre Messages 0 73.
Stop as soon as possible and inflate
the tyres to the pressure value
shown on the Tyre and Loading
Information label. See Tyre
Pressure 0 240.
When the Light Flashes First and
Then Is On Steady
If the light flashes for about a minute
and then stays on, there may be a
problem with the TPMS. If the
problem is not corrected, the light
will come on at every ignition cycle.
See Tyre Pressure Monitor
Operation 0 243.
Engine Oil Pressure Light
.
The
: warning light
illuminates for a short time when
the ignition is turned on to show
that the light is working.
If the light illuminates while driving:
.
The oil pressure is
dangerously low.
Stop the vehicle as soon as
possible and check the engine
oil level.
.
See Engine Oil 0 220.
.
Do not drive the vehicle with the
light illuminated. Contact a
Holden Dealer.
Caution
Engine damage may result if you
keep driving. Do not run the
engine. If the oil level is normal,
have the system checked by the
nearest Holden Dealer.
Low Fuel Warning Light
The . warning light illuminates for
a short time when the ignition is
turned on to show the light is
working.
.
The light illuminates when the
fuel tank is approaching empty.
Add fuel as soon as possible.
.
If the fuel tank is run to empty,
the fuel system must be bled.
See Diesel Fuel System
Bleeding 0 228.

Table of Contents

Related product manuals