Holden Colorado Owner Manual (Holden-Localizing-Australia/New Zealand-
13711071) - 2020 - CRC - 3/4/19
74 Instruments and Controls
is relearning the tyre positions on
your vehicle. The tyre positions
must be relearned after rotating the
tyres or after replacing a sensor.
See, Tyre Rotation 0 245, Tyre
Pressure Monitor System 0 241,
and Tyre Pressure 0 240.
Tyre Pressure Low Add Air
To Tyre
If equipped with the Tyre Pressure
Monitor System (TPMS), this
message displays when the
pressure in one or more of the
vehicle's tyres is low. This message
also displays with a vehicle picture
to indicate the location of the low
tyre. The low tyre pressure warning
light will also come on. See Tire
Pressure Monitoring System Light
0 65. You can receive more than
one tyre pressure message at a
time. If a tyre pressure message
appears on the DIC, stop as soon
as you can. Have the tyre pressures
checked and set to those shown on
the Tyre and Loading Information
label. See Tyre Pressure 0 240 and
Vehicle Weight 0 269. The DIC also
shows the tyre pressure values. See
Driver Information Centre (DIC)
0 67.
Transmission Messages
Press Clutch to Start Engine
Vehicles with manual transmission:
This message displays when
attempting to start the engine
without pressing the clutch pedal.
Service Transmission
This message displays if there is a
problem with the automatic
transmission. Contact a Holden
Dealer.
Shift Denied
Vehicles with automatic
transmission: This message
displays when the transmission has
not shifted to the selected gear as
the current vehicle speed will result
in an engine speed outside the
suitable range. See Manual Mode
0 183.
Grade Braking Active
Vehicles with automatic
transmission: This message
displays when the grade braking
feature has been activated while
driving on downhill gradients.
The message will only appear the
first time the feature activates in an
ignition cycle. See 'Grade Braking'
under Automatic Transmission
0 182.
Transmission Hot – Idle Engine
This message displays when
immediate action by the driver is
necessary to prevent transmission
failure.
Stop the vehicle as soon as it is
safe to do so and idle the engine
until the message turns off.
R
R displays when reverse gear is
engaged.
To Next Page
Loading...
