HOLDEN RC COLORADO 2010 - Active safety systems

ANTI-LOCK BRAKE SYSTEM
Anti-lock Brake System (ABS) continuously monitors the vehicle’s brake system and
prevents the wheels from locking, irrespective of the road conditions and tyre grip. It
starts to regulate the braking effect as soon as a wheel shows a tendency to lock. The
vehicle remains steerable, even in the event of panic braking, for instance on bends or
when swerving to avoid an obstacle.
WARNING
Do not let this special safety feature tempt you into taking risks when driving. Trafc
safety can only be achieved by adopting a responsible driving style. The vehicle’s
speed should always be adjusted to suit road and trafc conditions.
In an emergency braking situation the driver should keep full force on the brake
pedal, without pumping it. Pumping the brake pedal when ABS is tted will reduce the
braking efciency.
The ABS warning light is illuminated for a
few seconds when the ignition is switched
to the
ON position. If it does not go out,
or if it comes on during driving, there is
a defect in the ABS. The vehicle’s brake
system remains operational but without
ABS assistance. You should consult your
Holden Dealer as soon as possible.
The braking effect is regulated by the ABS
every millisecond during braking.
When your vehicle is in a critical braking
situation, ABS will make itself noticeable
through pulsing of the brake pedal and the
noise of the regulation process, thereby
reminding you to match your speed to the
road conditions, even though it is keeping
control of the braking.
Shortly after driving away, the system
performs a self-check. The self-check
may be audible.
Brake pad
Where possible, avoid hard braking. Smooth operation of the brake pedal will increase
the life of the brakes and reduce wear on the braking system. When the vehicle is
descending a steep slope, it is advisable to use the foot brake in combination with
lower gears to provide an engine braking effect.
Disc brake wear indicators: The front disc brakes have built-in wear indicators which
make a high pitched squealing warning sound when the brake pads are worn. This sound
can come and go, or be heard all the time when the wheels are rolling, but may stop
when the brake pedal is pushed down rmly. Extensive damage can result if the linings
are not replaced when needed. Contact your Holden Dealer if this sound is evident.
ACTIVE SAFETY SYSTEMS
3
4-24
Chapter 4
DRIVING