HOLDEN RC COLORADO 2010 - Page 153

BULB REPLACEMENT
Chapter 6
EMERGENCIES
6-19
Note If unsure of the bulb replacement process for any of the lamps, please have the
work carried out by a suitably trained service technician.
NOTES WHEN REPLACING BULBS
• Switch the ignition OFF and remove the key.
• Switch off the related switch.
• It is important to t only bulbs of the specied wattage.
• Do not touch bulbs or reectors with bare hands. Greasy ngers cause stains which
evaporate, eventually resulting in a dull reector. Grease spots on Halogen bulbs will,
within a short time, lead to bulb failure. Clean stained bulbs with methylated spirits.
BULBS TO BE CHANGED BY A HOLDEN DEALER
• Instrument panel lamps. • Fog lamps
3
.
• Turn signal lamps in exterior mirrors
3
. • Rear high level stop lamp.
• Front turn signal lamps.
HEADLAMPS
Low beam bulb
1. Open the bonnet and engage the
support.
Note To access the bulb reach through
the protective rubber cover.
2. Turn the bulb anticlockwise and
remove.
3. Remove the wiring connector from the
bulb.
4. Connect the new bulb to the wiring
connector without touching the glass.
5. Install the bulb by turning it clockwise.
6. Check the light operation.
Note The low beam bulb has a capacity of 51 watts.
High beam bulb
1. Open the bonnet and engage the
support.
Note To access the bulb reach through
the protective rubber cover.
2. Turn the bulb anticlockwise and
remove.
3. Remove the wiring connector from the
bulb.
4. Connect the new bulb to the wiring
connector without touching the glass.
5. Install the bulb by turning it clockwise.
6. Check the light operation.
Note The high beam bulb has a capacity of 60 watts.