BULB REPLACEMENT cont.
6-20
Chapter 6
EMERGENCIES
Front park lamps
1. Open the engine bonnet and engage
the support.
Note To access the bulb reach through
the protective rubber cover.
2. Turn the bulb holder anticlockwise
and remove.
3. Remove the bulb from the bulb holder.
4. Insert a new bulb into the bulb holder.
5. Install the bulb holder by turning it
clockwise.
6. Check the light operation.
Note The park lamp bulb has a
capacity of 5 watts.
Side asher lamps
1. Grasp the lens at the rear, push
forward and pull away from the body
of the vehicle. Separate the bulb
holder from the lens assembly by rst
rotating the bulb holder anticlockwise.
2. Disconnect the wiring harness
connector. The bulb pulls straight out
of the bulb holder.
3. Insert the new bulb into the bulb
holder. Install the bulb holder into the
lens housing.
Note The bulb holder only ts into the
lens housing one way. Therefore, keep
turning the bulb holder clockwise until
it ts into place and can be tightened.
4. Connect the wiring harness connector.
5. When inserting the light, rst locate
the rear of the housing into the body
before pushing the front inward to
engage the clip.
6. Check the light operation.
Note The side asher bulb has a
capacity of 5 watts.
To Next Page
Loading...
