HOLDEN RC COLORADO 2010 - Page 156

BULB REPLACEMENT cont.
6-22
Chapter 6
EMERGENCIES
Licence plate lights
3
1. Locate the bulb holder, accessible
from behind the rear bumper.
2. Grip the bulb holder by the plug
connector and rotate anticlockwise.
3. Remove the bulb holder from the
reector.
4. Remove the bulb from the bulb holder
by pulling it straight out.
5. Insert a new bulb into the bulb holder.
6. Install the bulb holder into the reector
by rotating it clockwise.
7. Check the light operation.
The bulb has a capacity of 5 watts.
Interior lights
Before removing the lens, close the front
doors so that the light is not live.
1. Lever out the lens by carefully inserting
a at-blade screwdriver between the
lens and the light housing.
2. Press the light bulb sideways toward
the spring clips to remove.
3. Insert the new bulb.
4. Press the lens back into the light
housing.
5. Check the light operation.
The bulb has a capacity of 10 watts.
Map lights
1. Carefully prise apart the lens assembly
at the clips shown in the diagram.
2. Remove the bulb holder by turning it
anticlockwise.
3. The bulb pulls straight out of the bulb
holder.
4. Insert the new bulb into the bulb holder.
5. Install the lens assembly.
6. Check the light operation.
The bulb has a capacity of 5 watts.