HOLDEN RC COLORADO 2010 - Page 74

Opening the bonnet
The bonnet lever is located inside the
vehicle, under the driver’s side of the
dashboard. To release the bonnet pull the
lever toward you. The bonnet releases
but is prevented from opening fully by a
safety catch.
To open the bonnet completely, reach
in under the centre of the bonnet and
move the safety catch upward, then raise
the bonnet.
To hold the bonnet in the open position, insert
the support rod into the slot provided.
Closing the bonnet
WARNING
To avoid injury and/or damage to the vehicle, check each time, before the bonnet is
closed, that the contact area is unobstructed.
Before closing the bonnet, return the support rod to its clip in the radiator grille. Allow
the bonnet to drop from approximately 25 cm above its closed position. After closing it
check that the bonnet has securely locked down.
WARNING
If while driving you notice that the bonnet has not been properly closed, pull the
vehicle over to the side of the road at the earliest possible moment and close the
bonnet correctly.
BONNET LOCK
Chapter 2
LOCKS
2-12