Holden Trailblazer Owner Manual (GMSA-Localising-Australia-11475197) -
2018 - crc - 3/15/17
Driving and Operating 207
.
All other braking functions will
continue to operate normally.
.
Once the brakes are at normal
temperatures, press
5 at
speeds below 50 km/h to
reactivate the DCS.
Cruise Control
The cruise control:
.
Maintains the vehicle's speed
without pressure on the
accelerator pedal.
.
Will only operate at speeds
above approximately 20 km/h.
.
Controls are located on the
steering wheel.
.
For safety reasons, cruise
control cannot be activated until
the foot brake has been
operated once.
{
Warning
Do not use the cruise control
when road or driving conditions
require varying speeds.
A consistent speed isn't practical
in heavy, varying traffic or on
winding, slippery or rough roads.
The cruise control does not apply
the vehicle's brakes. Therefore
the vehicle may gain speed when
going down steep hills.
When climbing steep hills, the
vehicle may lose speed. You may
need to switch off cruise control
and use the accelerator pedal.
Setting Cruise Control
1. Press ON OFF.
I illuminates white.
2. Accelerate to the desired
speed (above 20 km/h).
3. Push the switch down to SET/-.
I illuminates green.
To Next Page
Loading...
