Holden Trailblazer Owner Manual (GMSA-Localising-Australia-11475197) -
2018 - crc - 3/15/17
Vehicle Care 245
3. Rotate the relevant bulb holder
anticlockwise and remove it.
4. Remove bulb form the holder.
Push the bulb into the socket
slightly to the bulb.
5. Insert a new bulb into the bulb
holder and refit the holder into
the tail light assembly and
connect the electrical
connector. Close the cover and
engage.
6. Switch on the ignition, operate
and check all lights.
Reverse Lamps
1. Behind the rear bumper,
unscrew the screw to remove
the reverse lamp assembly and
disconnect the electrical
connector.
2. Unscrew the both screws to
remove the bulb holder.
To Next Page
Loading...
