HOLDEN Trailblazer RG MY18 - Tire Learn (If equipped); Vehicle Loading; TPMS Malfunction Light and Message; TPMS Sensor Calibration Process

Holden Trailblazer Owner Manual (GMSA-Localising-Australia-11475197) -
2018 - crc - 3/15/17
Vehicle Care 255
Caution
Tire sealants could damage the
TPMS sensors. TPMS sensor
damage caused by using tire
sealants is not covered by the
vehicle warranty.
Your vehicle has also been
equipped with a TPMS malfunction
indicator to indicate when the
system is not operating properly.
The TPMS malfunction indicator is
combined with the low tire pressure
light. When the system detects a
malfunction, the light will flash for
approximately one minute and then
remain continuously illuminated.
This sequence will continue upon
subsequent vehicle start-ups as
long as the malfunction exists.
When the malfunction indicator is
illuminated, the system may not be
able to detect or signal low tyre
pressure as intended. TPMS
malfunctions may occur for a variety
of reasons, including the installation
of replacement or alternate tyres or
wheels on the vehicle that prevent
the TPMS from functioning properly.
Always check the TPMS malfunction
light after replacing one or more
tires or wheels on your vehicle to
ensure that the replacement or
alternate tires and wheels allow the
TPMS to continue to function
properly.
See Tyre Pressure Monitor
Operation 0 256.
Tire Learn (If equipped)
The sensors are calibrated to the
tire/wheel positions, using a TPMS
relearn tool. See your dealer for
service.
Vehicle Loading
Select SET/CLR to define one of
following options:
Light : for comfort pressure up to
3 people.
ECO : for ECO pressure up to
3 people.
Max : for full loading.
The ECO tire pressure serves to
achieve the smallest amount of fuel
consumption possible.
Incorrect tyre pressures will impair
safety, vehicle handling, comfort and
fuel economy and will increase
tyre wear.
The tire pressure tables show all
possible tire combinations. See Tyre
Pressure 0 282.
If the tire pressure shall be reduced
or increased on a vehicle with tire
pressure monitoring system, switch
off ignition. After adjusting tire
pressure switch on ignition and
select the according setting as
shown previously in this section.
After inflating driving may be
required to update the tire pressure
values in the DIC. During this time
7 may light up.
Caution
The TPMS is not a substitute for
proper tire maintenance, and it is
the driver's responsibility to
maintain correct tire pressure,
even if under-inflation has not
(Continued)