Holden Trailblazer Owner Manual (GMSA-Localising-Australia-11475197) -
2018 - crc - 3/15/17
Vehicle Care 263
If the flat tyre is on the front of
the vehicle, position the jack
under the chassis rail between
the two braces as shown (1).
Rear position:
If the flat tyre is on the rear,
position the jack under the rear
axle and get as close as
possible to the shock
absorber (2).
When positioning the jack
under the rear axle housing,
confirm that the slot on the
upper side of the jack fits on
the axle.
17. Set the jack to the necessary
height before positioning it
directly below the jacking point
in a manner that prevents it
from slipping.
{
Warning
Failure to position the jack as
described could cause the vehicle
to slip off the jack.
(Continued)
To Next Page
Loading...
