HOLDEN VE II Series 2011 - Page 286

284 Vehicle care
3. Pull the bulb out of the bulb
holder.
4. Push the new bulb into the bulb
holder.
5. Install the bulb holder into the
lamp housing by rotating the bulb
holder clockwise.
6. Refi t the lamp into the rearward
facing locating tabs.
7. Push the forward facing edge
upward into the head lining until
fi rmly in place.
8. Check lamp operation.
Rear dome/reading lamps
with Rear Seat Entertainment
(RSE)
(W5W bulb)
If the vehicle has RSE:
1. Pull down on the left or right
edge of the lamp section using
only fi ngers.
2. From the rear, remove the bulb
holder from the lamp housing
by rotating the bulb holder
anticlockwise.
3. Pull the bulb out of the bulb
holder.
4. Push the new bulb into the bulb
holder.
5. Install the bulb holder into the
lamp housing by rotating the bulb
holder clockwise.
6. Refi t the lamp section by fi rmly
pushing it directly upward into
the console.
7. Check lamp operation.
MY11_VE_DOM_BOOK.indb 284MY11_VE_DOM_BOOK.indb 284 17/12/2010 9:31:34 AM17/12/2010 9:31:34 AM