Vehicle care 307
B
21. Rotate the handle clockwise from
position (A) to position (B).
22. Repeat Steps 19 to 21 until the
bottom of the fl at tyre is about
5 cm above the ground.
23. Remove the wheel nuts and
place in a clean, dry place.
24. Exchange the wheel on the
vehicle with the spare wheel.
25. Replace the wheel nuts and
lightly tighten with the wheel nut
wrench.
26. Lower the vehicle by reversing
the jacking procedure.
27. Remove the jack from under the
vehicle.
28. With the wheel on the ground,
use the extended wheel nut
wrench to tighten the wheel nuts
in the sequence shown.
Warning
To tighten the wheel nuts, the
wrench must be fully extended.
Spare wheel cover removal
(Sportwagon)
1. Lift the spare wheel cover.
2. Attach the hook to the tailgate
opening.
3. Unclip the press stud.
4. Support the cover and detach
hook from the tailgate opening.
5. Remove the cover.
6. Reverse the procedure to install
the cover.
Align the two locating tabs at the
forward edge of the cover with
the holes in the fl oor.
MY11_VE_DOM_BOOK.indb 307MY11_VE_DOM_BOOK.indb 307 17/12/2010 9:31:38 AM17/12/2010 9:31:38 AM
To Next Page
Loading...
