308 Vehicle care
29. Replace wheel trims or nut caps.
For a full wheel trim, line up the
tyre valve with the hole in the
wheel trim and align the wheel
trim clip-in legs.
30. Replace the tools, container and
fl at tyre in the boot/cargo area.
31. Tighten the upper retaining nut,
lower retaining nut and panel
fi rmly by hand.
32. Replace the spare wheel cover.
Warning
As soon as possible after
changing a wheel, have the wheel
nuts tightened with a torque
wrench to 170 ± 20 Nm (Newton
metres). Wheel nuts must be
tightened evenly to the correct
torque in the sequence shown
(refer to Step 28), as wheel nuts
which have not been tightened
properly could eventually allow
the wheel to come off while the
vehicle is moving.
Trolley jack or vehicle hoist
A
A. Front of vehicle
MY11_VE_DOM_BOOK.indb 308MY11_VE_DOM_BOOK.indb 308 17/12/2010 9:31:38 AM17/12/2010 9:31:38 AM
To Next Page
Loading...
