HOLDEN VE UTE II 2012 Series - Automatic Headlight; Changer; Headlight High;Low-Beam; System

Black plate (2,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
6-2 Lighting
Headlight High/Low-Beam
Changer
To activate high beam:
.
With the headlights on, push the
lever towards the front of vehicle
until it clicks, then release.
.
The high beam indicator light 3
illuminates on the instrument
panel.
To return to low beam:
.
Pull the lever towards the rear of
the vehicle.
To flash the high beam lights:
.
Pull the lever towards the rear of
the vehicle and release.
.
The high beam lights can be
flashed even if the headlights
and/or ignition are off.
Automatic Headlight
System
When the light control is in the
AUTO position, the headlights and
parking lights switch off and on
automatically depending on the
ambient light.
Note:
.
Keepthesensorcleananddo
not cover it. See Instrument
Panel Overview on page 5‑2.
.
The headlights, parking lights
and reverse lights are activated
by the approach lighting feature.
See Entry Lighting on page 6‑6.
{
WARNING
The automatic headlight sensor
cannot replace the driver’s
personal judgement of the
prevailing light conditions. For
example, the sensor is unable to
detect foggy conditions.
In situations such as this, set the
light switch to
2, otherwise your
safety and that of other road
users could be endangered.
.
Do not leave the headlights or
parking lights on when the
engine is not running.
.
To prevent the battery running
flat, the headlights and parking
lights switch off when the ignit ion
is turned to the lock position.
The lights stay off until th e
ignition is turned on or the lights
are switched on using the light
control.