Black plate (7,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-7
3. Open the bonnet. Lift the cover
upwards approximately 15 cm.
4. Pull the cover towards the front
of the vehicle.
Replacement
1. Place the cover over the rear
guide tabs.
2. Lower the front of the cover so
that the hole o n the left side
slides over the oil fill er cap.
3. Press down on both front
corners to engage the fasteners.
Pull upwards on the cover to
ensure it is secure.
Engine Oil
Checking oil level
The engine must be at operating
temperature and the ignition
switched off for at least 10 minutes.
1. Parkthevehicleonalevel
surface.
2. Remove the dipstick and wi pe
clean.
3. Insert the dipstick firmly.
4. Remove and read the oil level.
The level should be between the
area/marks (A) and (B). Add oil if
the level is at area/mark (A).
Dilution
When a vehicle is frequently driven
on short trips, the engine often f ails
to reach normal operating
temperatures.
.
The oil becomes diluted by fuel
and moisture that settles in the
oil pan.
To Next Page
Loading...
