Black plate (13,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-13
AB
V8 Engine
1. Check the coolant reservoir
level (B). Add coolant if low. See
Engine Coolant on page 10‑ 8.
{
DANGER
Do not remove the radiator c ap if
the engine and radiator are stil l
hot. Scalding fluid and steam can
be blown out under pressure,
which could cause serious burns.
(Continued)
DANGER (Contin ued)
Remove the engine cover if
required. See Engine Co ver on
page 10‑6.
2. Locate the radiator cap (A).
3. Cover the cap with a thick cloth
and rotate slowly anticlockwise
to remove.
{
CAUTION
Do not spill coolant on the
veh icle’s exterior surfaces as it
can damage the paintwork. If you
do, wash it off immediately.
4. As well as adding coolant to the
coolant reservoir, add coolant
directly through the radiator cap
opening until full.
5. Wait 30 seconds for the coolant
to settle.
6. Add more coolant if the level
drops.
{
CAUTION
Take care not to spill coolant on
the accessory drive belts.
If a spill occurs, rinse the belts
immediately with fresh wa ter.
7. Start the engine.
To Next Page
Loading...
