Black plate (22,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
10-22 Vehicle Care
3. Pull to remove the wiring
harness connector from the rear
of the bulb.
4. Press and unclip the bulb spring
retainer and pivot clear of
the bulb.
Note: Check the orientation of the
bulb tang for replacement.
5. Remove the bulb from the
headlight.
6. Fit the new bulb i nto the
headlight, ensuring the location
tang is located correctly.
7. Refit the bulb spring retainer into
its original position.
8. Install the wiring harness
connector and dust cap
(ensuring the rubber seal is in
place).
9. Install components removed in
Step 1.
10. Check light operation.
Inboard high beam
1. To access the headlights, see
“Front lights” under Bulb
Replacement on page 10‑19 and
follow the steps.
2. Rotate the inboard dust cap
anticlockwise and remove.
3. Remove the wiring harness
connector by squeezing the two
tangs on the harness connector
and pulling the connector
downwards.
To Next Page
Loading...
