Black plate (23,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-23
4. Twist the bulb anticlockwise to
remove.
Note: The different sized locating
tangs on the bulb base allow the
bulbtositcorrectlyintheheadlight
in one position only.
5. Twist the bulb clockwise to
install.
6. Install the wiring harness
connector and dust cap
(ensuring the rubber seal is in
place).
7. Install components removed in
Step 1.
8. Check light operation.
Parking lights
Front parking lights (Type A)
1. To access the headlights, see
“Front lights” under Bulb
Replacement on page 10‑19 and
follow the steps.
2. Remove the outboard low beam
dust cover to access the bulb.
3. Remove the parking light bulb
holder by pulling it straight out.
4. Remove the parking light bulb by
pulling it straight out of the
holder.
5. Insert the new bulb into t he
holder.
6. Install the holder.
7. Replace the low beam bulb dust
cap (ensuring the rubber seal is
in place).
8. Install components removed in
Step 1.
9. Check light operation.
Front parking lights (Type B)
1. To access the headlights, see
“Front lights” under Bulb
Replacement on page 10‑19 and
follow the steps.
To Next Page
Loading...
