Black plate (24,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
10-24 Vehicle Care
2. Remove the inboard high beam
dust cover to access the bulb.
3. Remove the high beam bulb to
access the parking light bulb.
See “Inboard high beam” earlier
in this section.
4. Remove the parking light bulb
holder by pulling it straight out.
5. Remove the parking light bulb by
pulling it straight out of the
holder.
6. Insert the new bulb into t he
holder, then install the holder.
Install the high beam bulb and
dust cap (ensuring the rubber
seal is in place).
7. Install components removed in
Step 1.
8. Check light operation.
Front Turn Signal Lights
1. To access the headlights, see
“Front lights” under Bulb
Replacement on page 10‑19 and
follow the steps.
2. Remove the outboard dust cap.
3. Rotate the bulb holder
anticlockwise and remove.
4. Lightly press the bulb and twist
anticlockwise out of the holder.
5. Insert the new bulb and install
the bulb holder.
Ensure that the same colour
bulb is used.
6. Install components removed in
Steps 1 and 2.
7. Check light operation.
To Next Page
Loading...
