Black plate (27,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-27
4. From the rear of the light,
disconnect t he wiring connector.
Push the tab at the bottom of the
connector to remove.
Tail Lights, Turn Signals,
Stoplights and Reverse
Lights
1. For access to the light assembly,
see “Tail light access” earlier in
this section.
2. From the rear of the assembly,
rotate the bulb holder
anticlockwise to release it from
its housing.
3. Lightly press the bulb and twist
anticlockwise out of the holder.
4. Install the new bulb by pushing it
into the holder and rotating it
clockwise.
Ensure that the same colour
bulb is used.
5. Install the bulb holder into
the lamp.
6. Install the components removed
in Step 1.
7. Carefully tighten the three plastic
light assembly securing nuts to
2.0 to 4.0 Y.
Do not overtighten.
8. Check light operation.
To Next Page
Loading...
