EasyManua.ls Logo

HOLDEN VE UTE II 2012 Series - Tyre Pressure; Wheels and Tyres

HOLDEN VE UTE II 2012 Series
296 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (39,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-39
Wheels and Tyres
Tyre placard
A
Correct tyre pressures are shown on
the tyre placard (A) in the driver s
door opening (B pillar).
The front tyre pressu res are shown
in the left column and the rear tyre
pressures are shown in t he right
column.
The placard may display the tyre
sizes and pressures using t he
following icons:
p: Tyre size, minimum load rating,
minimum speed rating
j:Tyrepressureatnormalload
i: Tyre pressure at
maximum load
o: Spare tyre pressures, refer
to Tyre Press ure on page 12 8.
Note: Full size spare: set to
i
tyre pressure.
Tyre Pressure
Keep the tyres at the recommended
pressures to avoid increased fuel
consumption and uneven or
premature tyre wear.
The correct pressures are shown on
the tyre placard and in the tyre
pressure table. See Tyre Pressure
on page 128.
.
Tyre pressure should b e
checked when cold as tyre
pressure will increase as the
tyres warm up.
.
Check the air pressure of tyres
(including the spare) weekly, to
ensure occupant safety, reduce
fuel consumption and increase
tyre life.
.
Check pressures when the
vehicle has been stationary for
over 3 hours. If tyre pressures
must be checked immediately
after driving more than 2 km,
increase the tyre placard
pressure by 10%.
.
Use a tyre pressure gauge to
check the tyres. Simply looking
at the tyres is not sufficient.
.
Replace any valve dust caps or
extensions.
.
Check the condition of the tyre
treads and inspect for stones or
abnormal wear.

Table of Contents

Related product manuals