HOLDEN VE UTE II 2012 Series - Page 26

Black plate (6,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
2-6 Keys, Doors, and Windows
Locking/unlocking from the inside
C
D
.
To l oc k, press Q (C) on the
centre con sole to lo ck both
doors.
This will not arm the alarm.
.
To unlock, press K (D) on the
centre console to unlock both
doors.
Door lock snibs
A
.
Pull the snib (A) to lock the door.
.
A door is locked when the lock
snib (A) is flush with the door
handle.
.
A door is unlocked when the
lock snib (A) is showing red.
.
Pulling the snib (A) on either of
the doors locks that door only.
.
Do not operate the driver’s door
lock snib when the door is open.
Free turning door locks
The door lock cylinder is designed
to free turn if it is forcefull y rot ated
without the correct key or if the
correct key is not fully inserted.
1. To reset, turn the lock with the
correct key fully inserted until its
slot is vertical.
2. Remove the key, then
re-insert it.
3. If the lock still free turns, turn the
key 180 degrees and repeat the
procedure.
Note: This feature is provided as a
theft deterrent, to prevent the lock
being forced open.
The force required to make the key
free turn reduces each time.
Do not attempt to demonstrate or
test this feature.
Always remember to fully insert the
key when locking and unlocking the
doors.
If any problems occur, contact a
Holden Dealer.