EasyManua.ls Logo

HOLDEN VE UTE II 2012 Series - Jump Starting

HOLDEN VE UTE II 2012 Series
296 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Black plate (62,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
10-62 Vehicle Care
{
CAUTION
If you drive away before the
securing cable has been wound
up the vehicle could be damaged.
13. Wind the extension bar/jack
handle clockwise to raise the
cable back up if the cable is
hanging under the vehicle.
{
WARNING
If any of the above spare wheel
carrier troubleshooting events
occur, do not use the spare wheel
carrier to hold a wheel until the
assembly has been inspected by
a Holden Dealer.
Jump Starting
Read the following warnings and
procedure in full before attempting
to jump start t he vehicle.
If you are still unsure about jump
starting, Holden strongly
recommends for your safety and
that of the vehicle that you seek the
assistance of a suitably trained
service technician.
{
WARNING
Do not push start or tow start
either a manual or an automatic
vehicle. If unburnt fuel were to
reach the catalytic converter and
ignite, the converter could
overheat or be destroyed by
backfire. Therefore, if the battery
is flat, jump start, but do not push
start the vehicle.
(Continued)
WARNIN G (Continued)
Batteries produce explosive
gases, contain corrosive acids,
and supply levels of electrical
current high enough to cause
burns. Therefore adhere to the
following when working near a
battery:
.
Do not attempt jump starting
directly from the battery.
.
Do not let the j umper lead
clamps touch each other or
other metal parts.
.
Do not allow the j umper leads
to contact any rotating engine
components.
.
Do not use open flames or
spa rks near the battery.
.
Do not smoke near the
battery.
.
Never use a quick charger to
start the engine.
(Continued)

Table of Contents

Related product manuals