Black plate (63,1)
Holden VE Ute Owner Manual (MY12.5) - 2012 - CRC - 6/28/12
Vehicle Care 10-63
WARNIN G (Continued)
.
The ba ttery must be removed
from the vehicle for
recharging.
.
When refitting the battery,
make sure the vent tube is
correctly installed.
.
Only use the recommended
battery, otherwise the electric
power management system
may not work correctly. Refer
to a Holden Dealer for battery
replacement.
.
Wear eye protection such as
safety glasses, and avoid
leaning over the battery.
.
Battery acid is corrosive. If it
gets on your skin, wash with
plenty of water immediately.
Ifitgetsinyoureyesyou
should not only flush with lots
of water, but should also seek
medical help. Battery acid
(Continued)
WARNIN G (Continued)
also damages paint and
fabrics. To minimise damage,
wash it off immediately.
.
Remove rings, metal watch
bands and other metal
jewellery before working
around the battery.
.
If a permanently connected
hands free telephone kit is
fitted to the vehicle, remove
the fuse for the telephone kit
before jump starting.
Remember to replace the
fuse afterwards.
Jump starting connection posts
The jump start positive (A) and
negative (B) posts are located in the
engine bay on the passenger side.
These posts are used instead of a
direct connection to a battery.
The positive jump start connection
is covered by a red cap.
1. Push the clip to release the top.
2. Remove to expose the terminal.
{
CAUTION
Do not make any connections at
point (C) as costly damage to the
vehicle could result.
To Next Page
Loading...
