User Manual LoRaWAN mME DTZ541 Three-phase electricity meter
30 / 31
10.2.1 Meter Control Message (MCMHDR) defined as:
LoRaWAN Meter Protocol V1
Off, do not send any uplink packets at the defined intervals until
the bit is set to 1 again. No messages (neither confirmed nor
unconfirmed) will be sent. The meter just keeps listening to new
commands.
On, send readings at the defined intervals
Send Now (To a single read, regardless of the sending interval)
Off, no need to send an additional meter reading in response to this
message.
On, regardless of the other parameters, the electricity meter as soon as
the duty cycle allows reading. Even if the “Send Reading Bit” is 0.
10.2.2 Unconfirmed Interval
4 byte integer denotes the multiple of 1 minute long interval in which the meter readings are sent as an unconfirmed
To Next Page
Loading...