When using the Hollywood SR1 Spare Tire rack, always remember the following points:
• Max Capacity: 35 lbs per Bike. Two Bikes.
• Keep bicycle tires at least 1 ft (30cm) away from exhaust pipe
• Tighten all straps before and after mounting bikes
• Check the rack, bicycles and strap tightness/condition regularly during use
• Drive slowly when used on bumpy or dirt roads
• NOT TO BE USED ON ANY TRAILER, FIFTH WHEEL OR TOWED VEHICLE
Caution: Be sure that the spare tire is properly mounted to the vehicle and that the mounting
bracket/apparatus is suitable and strong enough to support the entire weight of the spare tire, bike rack
and bicycle(s). Contact the vehicle manufacturer if there are any questions regarding the strength of the
tire mounting apparatus.
Tools Needed: 9/16” socket wrench or and adjustable wrench
The Hollywood Spare Tire Rack comes fully assembles from the factory, and set up for “center mounted”
spare tires. If your spare tire is side mounted, see assembly step 7. The rack easily attaches to the spare
tire using an adjustable rear brace in conjunction with three nylon attachment straps.
The “side” attachment strap goes around
the tire and prevents rotational movement.
The two “rear” straps pass behind the tire
and keeps the rack tight and secure
against the front of the spare tire.
To Next Page
Need help?
General
