page 20 Compass
™
Stainer Operator’s Manual
Once a desired program number is entered (program number followed by the ENTER key), the
software will check if the selected program exists in the memory. If the program exists in the memory,
the system will start the execution of the program once the user presses ENTER.
The transport mechanism is initialized first and
“MOVING THE RACK…”
message is displayed. Once
the rack is at a station, the run time status is displayed as follows:
ENTER PROGRAM #: 0
ENTER: ACCEPT NUMBER
RUN PROGRAM #: 1
TP_95%_ALC
REMOVE BATH COVERS!
ENTER: CONTINUE
RUN PROGRAM #: 2
REMOVE BATH COVERS!
ENTER: CONTINUE
Select Program #1
Select Program #2
(for example)
Pre-loaded program for use with
ThinPrep Imaging
User-configured stain program
To Next Page
