To Next PageTo Next PageWhat to do if my HOLZMANN MASCHINEN FKS 305VF-1600 Power Tool does not start?
If your HOLZMANN MASCHINEN Power Tool doesn't start, try the following: ensure the cover plate is closed, turn the emergency OFF switch to the right to unlock it, replace the fuse, wait until the engine cools down, and repair any defective circuits or faulty phases.
Why is the workpiece clamped while advancing in my HOLZMANN MASCHINEN FKS 305VF-1600 Power Tool?
If the workpiece is clamped while advancing in your HOLZMANN MASCHINEN Power Tool, it could be due to a dull blade or a riving knife thickness that doesn't match the blade. Replace the dull blade with a sharp one. Ensure the splitting wedge thickness is greater than or equal to the blade thickness.
How to prevent burn marks on the workpiece with HOLZMANN MASCHINEN Power Tool?
Burn marks on the workpiece when using your HOLZMANN MASCHINEN Power Tool are often caused by a blunt blade. Replacing the blade should resolve this issue.
What to do if the finished size is incorrect on my HOLZMANN MASCHINEN Power Tool?
If the finished size of the machined workpiece is incorrect for the cutting width on the rip fence of your HOLZMANN MASCHINEN Power Tool, the measurement scale for the cutting width display may be adjusted incorrectly. To set the dimension scale: cut a workpiece on the rip fence, measure the workpiece, and move the measuring scale so that the measured average width is shown at the edge of the ruler.
How to fix a sliding table higher than the machine table on HOLZMANN MASCHINEN FKS 305VF-1600 Power Tool?
If the sliding table at end positions is higher than the machine table on your HOLZMANN MASCHINEN Power Tool, the lower rollers may be set incorrectly. Adjust the lower rollers to correct this.
General| Brand | HOLZMANN MASCHINEN |
|---|---|
| Model | FKS 305VF-1600 |
| Category | Power Tool |
| Language | English |
