Home HME010393N - CHANGING WASH PROGRAMS; DISHWASHER STATUS INDICATORS; POST-CYCLE ACTIONS

19
HOW TO SELECT A WASH PROGRAM
How Do I Change the Wash Program?
You can change your wash cycle only if it has been running for a short time and the detergent has not yet been


To change the wash program, hold Start/Cancel button over three seconds. The machine will enter standby mode
where you can then change the setting. Press Mode button to select the new program. See “How to Select a Wash
Cycle” section for detailed information.
The lights will show the state of the dishwasher:
a) All phase lights off Stand by
b) Display light steady (not blinking) Paused
c) Display light blinking Running
What Do I Do Aer the End of the Cycle?

to turn off the dishwasher. Shut off the water supply and open the door. Wait a few minutes before handling your
dishes to allow them to dry and become less susceptible to damage. The dishwasher goes into standby mode, if
there is no actions are made, the dishwasher will turn off automatically after 30 minutes.
How to Turn off the Dishwasher
The program has ended when all of the phase lights are off. Then:
1. Press the power button to turn off the dishwasher.
2. Turn off your water tap.
Note: Open the Door Carefully

dishwasher to prevent damage.
To do this, open the dishwasher door and leave it ajar for a few minutes. This will allow your dishware to cool and dry.
How to Unload the Dishwasher
Note that it is normal for the dishwasher to be wet inside.
WARNING! It is dangerous to open the door when washing, because hot water may scald you.
OPERATING INSTRUCTIONS