Home HME010393N - DISCONNECTING THE DISHWASHER; STARTING THE DISHWASHER

9
POSITIONING THE DISHWASHERWATER CONNECTION
INSTALLATION
NOTE: Hard water conditions will negatively affect the performance of your dishwasher. Hard water conditions will also


of the dishwasher once a week while it is empty, using 1 cup of white vinegar.
WARNING! FAILURE TO RELIEVE WATER PRESSURE BEFORE DISCONNECTING THE QUICK-CONNECT FROM THE FAUCET,
WILL RESULT IN BACK-PRESSURE OVER-SPRAY. THE TEMPERATURE OF INCOMING WATER CAN BE VERY HOT, AND BACK-
PRESSURE OVER-SPRAY COULD CAUSE SEVERE BURNS AND/OR SCALDING.
DANGER! DO NOT LET CHILDREN DISCONNECT THE DISHWASHER; CLOSE SUPERVISION OF CHILDREN IS ALWAYS
IMPORTANT AROUND DISHWASHERS.
ATTENTION: The content of this manual can be very helpful to the users. After installation, please make sure to keep
this manual.



2. Connect the hexagonal connector of the drain hose to the drain port on the back of the dishwasher.
Do not over tighten to avoid damage to its threads.
3. Connect the star-shaped connector of the inlet hose to the inlet port on the back of the dishwasher.
Do not over tighten to avoid damage to its threads.
4. Connect the circular connector of the drain hose onto the longer (bottom) male connection on the quick connect.

6. Attach the quick connect onto the faucet adapter, by pulling down the outer locking collar on the quick connect,
while pushing the quick connect upward onto the faucet adapter.
7. When the quick connect snaps onto the faucet adapter, release the locking collar. Check that the connection is secure.
8. Slowly open the hot water line and check for any sign of water leaks at all hose connections. If leaks are located,
immediately close the water supply and repair the hose connections.
IMPORTANT
1. Once the water supply line is opened, the inlet hose will be pressurized, even if the water supply line is immediately
closed.
2. To relieve water pressure from inside the inlet hose, make sure the water line faucet is closed. Then, press and hold the

How to Disconnect the Dishwasher
1. Shut off the water supply at the faucet.
2. Disconnect the power supply cord.
How to Start the Dishwasher
The following things should be checked before starting the dishwasher.

2. The inlet valve is open.
3. There is no leakage at the conductor connections.
4. The wires are tightly connected.

6. The inlet and drain hoses are knotted.
7. All packing materials and printings are taken out from the dishwasher.