11
INSTALLATION
POWER CORD WRAP
OPERATION
Type 2: Sliding Window Installation
1. Cut Foam Seal A and B strips to the proper lengths and remove the adhesive backing. Attach them to the window sash and frame as shown.
2. Insert the Window Slider assembly into the window opening.
3. Cut the non-adhesive Foam Seal C strip to match the width of the window. Insert the seal between the glass and the
window frame to prevent air and insects from getting into the room.
4. If desired, install the security bracket with 2 screws as shown.
5. Insert the Window Slider Adapter into the hole of the Window Slider.
Foam seal C
(Non-adhesive type)
Foam seal A
(Adhesive type)
Window slider A
Window slider B
(if required)
2 Screws
Security
Bracket
Power Cord Wrap
Attach Power Cord Wrap to back of unit.
To Next Page
Loading...
