10
CHANGING BOTTLES
A ashing red light alerts you when your bottle is empty. Replace the bottle as soon as possible.
CAUTION: Do not dispense hot or cold water if the red light is ashing as you could empty the tanks and cause the
dispenser to overheat.
1. Open the Dispenser door.
2. Slide the empty bottle out of the cabinet.
3. Remove the probe assembly from the empty bottle. Place the probe assembly on the probe hanger. See Figure on
Page 9.
4. Set the empty bottle aside.
5. Place the new bottle outside of the cabinet. Remove the entire plastic cap from the top of the bottle. Clean the
outside of the new bottle with a cloth.
6. Place the probe into the bottle. Slide the collar down until it clicks in place. Push the head down until the tubes hit
the bottom of the bottle.
7. Slide the bottle into the cabinet and close the door.
OPERATION
To Next Page
Loading...