Preparing for sauna heater installation
Check the following before installing the sauna heater.
Please ensure that the heater is the recommended heater for the size of the sauna room. The
minimum sauna room height must be a min 6.1ft (74 inches) and no greater then 8ft (96 inches)
A sauna room that is uninsulated or has masonry stone walls will extend the preheating time for
the sauna heater. Each square meter of plastered ceiling or wall surface adds 1.2 m3 to the sauna
room's volume.
Ensure that the suitable electrical specifications have been met that match your specific sauna
heater.
Ensure that the heater has been placed with the correct spacing to combustible materials (See
page 5)
Installation of Sauna Heater
Follow the safety clearance specifications on page 6 when installing the sauna heater.
•The sauna heater is a floor-standing model. The base or floor must be solid, because the sauna
heater, with rocks can weigh up to 180-200 pounds.
•The sauna heater is levelled by the adjustable legs to ensure the heater is always level.
•The sauna heater needs to be fixed directly onto the floor, wall or to the sauna bench module by
using suitable anchors provided by Homecraft.
•Walls or ceilings must not be clad with fibre reinforced plaster board or other light-weight
cladding, because they may cause a fire hazard.
•If the sauna heater will not heat up, please check that:
•The power is on
•The main fuses of the sauna heater are intact
•If there any error messages on the sauna control panel. In case of an error message on
the control panel
Please refer to the control panel instructions.
THE PERSON INSTALLING THE SAUNA HEATER SHOULD LEAVE THESE INSTRUCTIONS
AT THE PREMISES FOR THE FUTURE USER.
To Next Page
Loading...
