Need help?Do you have a question about the Homelite MP38 and is the answer not in the manual?
Safety advice for the operator, including eye protection, gloves, and hearing protection.
Guidelines for installing and handling cutting wheels to prevent breakage and ensure safety.
Cautionary notes on the use and potential hazards of carbide-tipped blades.
General safety rules for operating the saw, including fire prevention and handling.
Safety recommendations for the operating environment, including ventilation and fuel handling.
Specific torque values for wheel arm components and assembly.
Troubleshooting steps for fuel system issues, including checks for spark plug, fuel supply, filter, and lines.
Troubleshooting steps for ignition system problems, including spark plug tests and electronic components.
Instructions for safely mounting the cutting wheel, including blotters and flange usage.
Steps for mounting the saw's arm, including belt and clutch drum alignment.
Procedure for adjusting the drive belt tension to ensure proper operation and prevent slippage.
Safety warnings and instructions for refueling the unit, emphasizing safe practices.
Detailed steps for starting the engine, including choke usage, and procedures for stopping the unit.
Instructions for removing, cleaning, and replacing the air filter and prefilter elements.
Guidance on adjusting the carburetor settings for optimal engine performance.
Recommendations for adjusting carburetor settings when operating the saw at high altitudes.
Information on fuel filter, fuel line, pulse line, and fuel tank venting for proper operation.
Procedures for performing static tests to diagnose fuel system issues, including fuel pump integrity.
Method for pressure testing the carburetor to check its internal components and seals.
Steps for disassembling and inspecting various fuel system components for damage or wear.
Instructions for checking, cleaning, and replacing the spark plug for optimal ignition.
Importance of keeping cylinder cooling fins clean for preventing engine overheating.
Maintenance of the muffler and spark arrestor, including cleaning and replacement.
Routine maintenance and instructions for starter rope replacement.
Detailed steps for replacing the starter rope, including safety precautions.
How to test for ignition spark and set the air gap between the rotor and module.
Procedure for testing the ignition switch continuity using a VOM meter.
Maintenance of the muffler and spark arrestor, including cleaning and replacement.
Instructions for changing the arbor spacers on the wheel.
Steps for removing and disassembling the wheel arm, including belt tension adjustment.
Procedure for removing and installing bearings and lubricating the wheel guard collar.
Steps for reassembling and installing the wheel arm, including bearing and shaft installation.
Service and inspection of the clutch drum and drive pulley, including potential trouble symptoms.
Detailed steps for removing and inspecting the clutch, including shoe and spring checks.
General overview of engine disassembly and inspection procedures.
Steps for removing the cylinder and piston, including piston pin and retaining ring.
Procedure for assembling the crankshaft and crankcase halves, including bearings and seals.
Steps for installing the crankshaft seal using a seal protector and press.
How to assemble the piston and cylinder, including piston pin, rings, and gasket.
Instructions for routing ignition leads and mounting the ignition switch.
Steps for assembling the carburetor, gaskets, and air filter adaptor.
Instructions for assembling the handle, including isolator springs and screws.
How to perform engine compression tests to identify potential issues.
Procedure for pressure testing the crankcase and cylinder for air leaks.
To Next Page
General
