If necessary, fill the reserve tank
to the MAX mark. Install the
reserve tank cap.
Install the radiator cap, and
tighten it fully.
Start the engine and hold it at
1,500 rpm until the radiator fan
comes on. Turn off the engine.
Check the coolant level in the
radiator and add coolant if needed.
Remove the radiator cap. Fill the
radiator with coolant up to the
base of the filler neck.
Start the engine and let it run until
the radiator fan comes on two
times. Then stop the engine.
Pour Honda All Season
Antifreeze/Coolant Type 2 into
the radiator up to the base of the
filler neck. This coolant is a
mixture of 50 percent antifreeze
and 50 percent water. Pre-mixing
is not required.
The cooling system capacity is:
Install the radiator cap, and
tighten it to the first stop.
Fill the reserve tank to the MAX
mark. Install the reserve tank cap.
Check the level in the radiator,
add coolant if needed.
Start the engine and let it run for
about 30 seconds. Then turn off
the engine.
10.
19.
18.
17.
16.
15.11.
12.
13.
14.
Cooling System
Maintenance
175
RREESSEERRVVEE TTAANNKK
FFiillll uupp ttoo hheerree
5.3 (1.40 US gal , 1.17 Imp gal)
To Next Page
Loading...
