14
Driver and Passenger Safety
If the seat belt touches or crosses
your neck, or if it crosses your
arm instead of your shoulder, you
need to adjust the seat belt anchor
height.
To adjust the height of a seat belt
anchor in the front or the rear,
press the release button and slide
the anchor up or down as needed
(it has four positions).
Never place the shoulder portion
of a lap/shoulder belt under your
arm or behind your back. This
could cause very serious injuries
in a crash.
Using the Lap Belt
Insert the latch plate into the
buckle marked
CENTER.
If the belt is too short, hold the
latch plate at a right angle and
pull on the plate to extend the
belt. Then insert the latch plate
To Next Page
Loading...
