Honda 2004 CRF250X - Cam Chain Tensioner;Cam Chain Guide Installation; Cylinder Head Disassembly

CYLINDER HEADIVALVES
INSTALLATION
Apply locking agent to the cam chain tensioner bolt
threads.
Install the washer, co llar, cam chain tensioner and b;;;;~ !!!
bolt.
Tight en the bolt to the specified torque.
TORQUE: 12 N'm (1.2 kgf ·m, 9 Ibf.ft)
Install the cam chain guide by aligning the guide
end with the groov8 in the crankcase and the tab
with the groove in the cylinder.
Install the following:
- Flywheel (page 11 - 6)
- l eft crankcase cover (page 1'-7 )
- Cylinder head (page 8·25)
CYLINDER HEAD DISASSEMBLY
Remove the cylinder head (page 8-12).
Loosen the insulator band screw and remove the
insulator from the cylinder head.
Remove the
bol t, O-ring and water hose pipe.
'04 - '06 Califorma Remove the boost joint and sealing washer.
rype. After '06:
SCREW
w,rn"R;HOSE PI PE
BOLT
INSULATOR
8OClSTJOINT
8-15