Honda 2004 CRF250X - Front Wheel Installation

FRONT WHEEl/SUSPENSION/STEERING
Install the brake disc onto the wheel hub wi th the
drive mark facing out.
Install the brake disc bolts and nuts.
T
ighten the nuts to the specified t orque .
TORQUE: 16 N·m (1.6 kgf ·m, 12Ibf·ft)
Pack a new left dust seal lip with grease and install it
into the hub .
Check the left side collar and tripmeter gear box for
wear or damage.
Install the left side collar to the wheel.
Install the gear box while aligning its tabs of the
gear box with the grooves on the wheel.
INSTALLATION
Clean the clamping surface of the axle and axle
holders .
Install the front wheel between the fork legs wh ile
inserting the di sc between the pads, and align the
tab of the tripmeter gear as shown.
Check that the tripmeter gear box O- ring is in good
condition, replace if necessary.
Apply a thin layer of grease to the axle and insert
the axle from the right side.
Install and tighten the axle nut to the specified
torque.
TORQUE: 88 N·m (9.0 kgf ·m, 65 Ibf.ft)
T ighten the left axle holder bolts to the specified
torque.
TORQUE: 20 N·m (2.0 kgf ·m, 14 Ibf · ft)
13-11